|
| High
Performance Fortron 300W |
- ATX Switching
Power Supply
- Microprocessor:
Intel, AMD (Athlon 600Mhz - 1.2 Ghz Approved)
- Sufficient
Power:
A True 300W Continuous Output; Suitable for Full Tower, Workstation or Mini-Server Requiring
Large Power
- Built-in Noise
Killer: This
power supply uses a special ball bearing fan to reduce noise with built-in
noise killer
- Total of
10 Connectors :
Two Types of Motherboard Connectors (20 Pins or 6 Pins);
Six 4 Pins Power Connectors; Two Floppy Connectors
- Important
Note:
- 1 Year Warranty
 |
| Click
below for detailed images. |
|
|
|
|
|
|
Features
|
- CSA,
UL, IEC,
VDE, NEMKO, TUV, FCC Certified
- High
Efficiency
- Low
Noise and Ripple
- Output
over Voltage Protection
- Short
Circuit Protection on all Outputs
- Resettable
Power Shut Down
- Internal
12 VDC Fan Provided
- 100%
Burn-in under High Ambient Temperature
- MTBF
Above 100,000 Hrs at 25 Degree Celsius
- 100%
Hi-pot & ATE Tested
- Built-in
EMI Filter
|
|
Input
Characteristics
|
-
Voltage:
95-132 VAC or 180-264 VAC Switchable
-
Frequency:
47Hz to 63 Hz
-
Input
Current: 10 Amps Maximum/115 Vrms, 60 Hz; 5 Amps Maximum/230
Vrms, 50Hz
|
|
Output
Characteristics
|
| Output
Voltage |
Min.
Load |
Normal
Load |
Max.
Load |
| +3.3V |
0.2A |
14.0A |
0.2/14A |
| +5V |
2.0A |
14.0A |
30/20.7A |
| +12V |
0.2A |
6.0A |
11.0A |
| -12V |
0.0A |
0.4A |
0.8A |
| -5V |
0.0A |
0.15A |
0.3A |
| +5Vsb |
0.0A |
1.0A |
2.0A |
|
|
Specification
|
- Remote ON/OFF
Control: The power supply shall accept a logic collector
level which will disable/enable all output voltage
(excluding +5V standby).
- Temperature
Range: Operating O Deg. Celsius ~ 50 Degree Celsius;
- Non-operating
Range: -20 Deg. C ~ +80 Deg. C
- Temperature
Coefficient: 0.01 % Deg. C
- Transient
Response: Output Voltage Returns in less than 1 ms Max.
following a 35% Load Change
- Hold
Up Time: 16ms Min. at Full Load & Nominal Input Voltage
- Dielectric
Withstand: Input/Output 1800 VAC for 1 Sec. Input to Frame
Ground 1800 VAC for 1 Sec.
- Humidity:
90~95% RH
- Efficiency:
65% Min., 70% Typical, at Full Load
- Power
Good Signal: On Delay 100ms to 500ms, Off Delay 1ms
- Overload
Protection: 150% Max
- Inrush
Current: 45A Max. for 115 VAC or 80A Max for 230 VAC at 25
Deg. C Ambient Cold Start
- Over
Voltage Protection: +5V Output: 6.5V; +3.3V Output:
4.6V; +12V Output: 15.5V
|
|
